Installation Manual

C4687M-C (7/13) 21
CONNECTING TO THE NETWORK
The SM5200 comes equipped with primary and secondary network interfaces, allowing the unit to act as a gateway to the Endura network.
• The primary network interface connects to your private Endura network, and it is the interface over which all optional system manager
services operate. You must configure the primary interface.
• The secondary network interface connects to an alternate network, providing access to Endura from outside the private network. Before
proceeding, ensure that your IT department has reserved and issued the appropriate IP address range for the Endura system.
To configure your network interfaces, log on to the SM5200’s Web configuration application; for more information, refer to the SM5200 System
Manager Configuration manual.
NOTE: Connect the unit to a Gigabit Ethernet network. Always use standard Cat5e or better UTP cabling.
To connect the unit to a network:
1. Connect an Ethernet cable to a network connection on the rear of the unit.
2. Connect the other end of the network cable to an available ethernet port.
Figure 18. Network Cable Connection
SECONDARY
NETWORK