Installation Manual

18 C4687M-C (7/13)
7. Slide the SM5200 with attached chassis brackets into the sliding brackets. This step may require two people to lift and slide the unit into
place.
Figure 12. Installing the Unit in the Rack
NOTE: Align the chassis brackets with the first slot on the sliding brackets when installing the unit (refer to Figure 13). This ensures that
the unit properly slides in and out of the rack. To remove the unit from the rack, pull it out of the rack until the sliding bracket locks into
place, and then press the release lever on both chassis brackets.
Figure 13. Aligning the Chassis Bracket and the Sliding Bracket
8. Insert and tighten two M5 x 8L-H2.5 round head nickel screws above and below the chassis handles to secure the unit in the rack.
WARNING: When sliding the unit out, take care to prevent it from falling out of the rack.