Installation Manual

C4687M-C (7/13) 15
RACK-MOUNTING THE UNIT
1. Install the chassis handles (supplied):
a. Align the screw holes on the chassis handles with holes near the front of the chassis.
b. Insert and tighten the four Phillips flat head screws (supplied).
2. Remove the chassis brackets from the sliding brackets (both supplied):
a. Slide both chassis brackets away from the sliding brackets until they lock in place.
b. Release the chassis brackets from the sliding brackets. Press down on the release for the right set of rails and press up for the left set
of rails.
Figure 7. Removing the Chassis Brackets from the Sliding Brackets