Installation Manual

C3401M-D (3/09) 19
RECESSED
1. On top of the dome drive is an opening for an optional translator board. The opening has a cover that
must remain in place if a translator board is not required. A taller cover is supplied if a translator
board is installed.
If you are going to install a translator board, follow the instructions that come with the translator
board.
If you are not going to install a translator board, save the taller cover in case you ever choose to install
a translator board.
2. Remove the spring paddle flex assembly from the surface mount ring (refer to Figure 7).
Figure 7. Spring Paddle Flex Assembly
3. Remove the surface mount ring from the dome drive as follows (refer to Figure 8):
a. Place your fingers on the circular marks located on the sides of the surface mount ring.
b. Pinch the sides.
c. Lift and remove the surface mount ring from the dome drive.
Figure 8. Removing the Surface Mount Ring
4. Attach the spring paddle flex assembly to the dome drive using the two #8-32 x 3.50-inch machine
screws (supplied). Thread the screws into the ends of the spring paddle flex assembly so the
paddles remain at the end of the screws (refer to Figure 9 on page 21).

Dome drive

Surface mount ring