Instructions

28
2.2.2.7 Firewall
Set the Firewall function. A firewall is a system or group of systems that manages access between two networks.
FIGURE 2-20: FIREWALL CONFIGURATION
Firewall
1. Select Allow or Deny mode to enable this function. The default setting is Off.
2. Check Enabled to enter IP address in the Address field. Up to ten addresses can be enabled for entry.
3. Click the Save button to save the settings, or click the Reset button to clear all of the information you entered without
saving it.
2.2.2.8 FTP
This page will enable or disable FTP and SFTP access to this camera. In this page, users can activate both FTP Server and
SFTP Server to access the SD card for recordings. Enabled the FTP and SFTP, and use this function.
FIGURE 2-21: FTP SETTINGS
FTP Setting / SFTP Setting / General Settings
1. Select the Enabled check box to activate the FTP function and/or SFTP function, and follow the following
procedures to set up related settings.
NOTE: It is not possible to enable SFTP and SSH at the same time.
2. Enter a Username if you activated the FTP function.
3. Enter a Password associated with the Username.