Instructions

19
 HTTP Port
NOTE: The HTTP port number must remain at the default setting (80) when connecting to a Pelco video management
system (VMS) platform. If connecting to a Pelco VMS, do not change the HTTP port setting.
1. Click in the HTTP Port box and highlight the text.
2. Type the new port number in the HTTP Port field. The default port for HTTP communications is 80.
3. Click the Save button to save the settings, or click the Reset button to clear all of the information you entered without
saving it.
 HTTPS Port
NOTE: The HTTPS port is not configurable unless you have set TLS Mode to Optional or Required and installed a security
certificate.
1. Click in the HTTPS Port box and highlight the text.
2. Type the new port number in the HTTPS Port field. The default port for HTTPS communications is 443.
3. Click Save. If you have changed the setting in error, you can click reset to revert to the previously saved setting.
 RTSP Port
1. Click in the RTSP Port box and highlight the text.
2. Type the new port number in the RTSP Port field. The default port for RTSP communications is 554.
3. Click the Save button to save the settings, or click the Reset button to clear all of the information you entered without
saving it.
IPv4 Settings
Enable or disable the Dynamic Host Configuration Protocol (DHCP) server. DHCP automatically assigns an IP address to
the device if there is a DHCP server on the network.
 If DHCP is set to On, the IP address, subnet mask, gateway, and DNS server settings are read-only text.
 If DHCP is set to Off, these settings must be manually changed.
Change the following network settings as required:
1. IP Address: The address of the camera connected to the network.
2. Subnet Mask: The address that determines the IP network that the camera is connected to (relative to its address).
3. Gateway: The router that accesses other networks.
4. DNS Servers: The addresses of the dedicated servers that translate the names for Web sites and hostnames into
numeric IP addresses.
5. Click the Save button to save the settings, or click the Reset button to clear all of the information you entered without
saving it.