Instructions

17
2.2.1.3 Firmware
System Information
The System Information page fields are read-only and include the firmware version, hardware version, model number, and
serial number of the system are revealed here as below figure. This information is typically required by Pelco Product Support
for troubleshooting purposes.
FIGURE 2-7: SYSTEM INFORMATION
Firmware Update
Users can update system firmware if available. Ensure a user has been created before updating camera’s firmware. All camera
motions will shut down during firmware update. Please close any other screens before a firmware update. Never disconnect
power or LAN cable during the firmware update process. Disconnecting power during a firmware update will cause the update
to fail. It takes approximately 3 minutes for the unit to reboot after firmware update process.
FIGURE 2-8: FIRMWARE UPDATE
2.2.1.4 Storage Management
Device Information
The detailed information of an inserted SD card will be shown in this page where the device type, total capacity, free space and
status are presented explicitly for users to preview.
FIGURE 2-9: STORAGE MANAGEMENT SETTINGS
Device Setting
The “Format Device” function is deployed here for further employment. Select either the “vFAT” or “ext4” option from the
Format Device dropdown menu, depending on preferred preference, and click on “Format” button to format an SD card.