Operation Manual
Table Of Contents
- Important Notices
- Accessing the Camera
- Accessing the Live Video Page
- System Menu
- Using the Network & Security Menu
- Using the Imaging Menu
- Configuring Exposure Settings
- Configuring Focus Settings
- Setting White Balance
- Using Window Blanking
- Configuring Options in the PTZ Menu
- Using A/V Streams Menu
- Events
- Configuring Sources
- Configuring Handlers
- Configuring an Event Handler: Send Email
- Configuring an Event Handler: Upload JPEG to FTP Server
- Configuring an Event Handler: Write JPEG to SD Card
- Configuring an Event Handler: Run Pattern
- Configuring an Event Handler: Go to Preset
- Configuring an Event Handler: Run Tour
- Configuring an Event Handler: Run Scan
- Configuring an Event Handler: Open/Close Relay
- Configuring an Event Handler: Display Overlay
- Configuring an Event Handler: Play Audio
- Configuring an Event Handler: Write Recording to SD Card
- Configuring an Event Handler: Upload Recording to FTP Server
- Deleting an Event Handler
- Analytic Configuration
- Event Stream
- Contacting Pelco for Troubleshooting
Spectra Enhanced 7 Operations Manual, PTZDome Cameras
C6653M-B | 06/20
44
dependent on the analytic behavior you are configuring. Drawing tools include:
l Rectangle Tracks objects in a defined rectangular zone and triggers an alarm if the objects move in
the same direction as defined.
l Polygon: Tracks objects in a defined zone and triggers an alarm if the objects move in the same
direction as defined.
l Line: Tracks objects that cross a line and triggers an alarm if the objects move in the same direction
as defined.
l Rectangular Excluded Zone: Ignores objects inside a defined rectangular zone.
l Polygon Excluded Zone: Ignores objects inside a defined zone.
l Set Object Size filters: Allows the user to set the minimum and maximum object size for a zone.
Objects that fall outside these limits will not be detected.
l (AutoTracker Only) Display Size: Display Size: Sets the relative size of a tracked object in
comparison to the surrounding scene and maintains the size of the object within the scene.
Using the Zone List
A zone drawn with any of the Drawing Tools will appear in the Zone list section.
1. Click the zone from the list that you wish to configure.
2. Click Save to activate the Zone Settings options for that particular zone.
3. Click X to delete the zone from the Zone list.
Using AutoTracker Zone Settings
You can establish the conditions under the Zone Settings section to determine which events are triggered
for a Select Behavior. The availability of settings depends on the chosen Select Behavior.
l Name: Type a name of your choosing for the selected Zone.
l Direction: Determines the direction of motion a zone should track. Events will only be triggered
when your camera detects motion in the specified direction.
l Enable Alarm: Enables a zone alarm. Analytic events for the zone will appear in the event stream
when viewing live video, and trigger event handlers if the Analytic Event source is enabled.
l Alarm severity: Defines the severity of alarms triggered. Alarm severity helps you and other users
prioritize alarms.
l Alarm at: Determines the number of objects entered into a zone that will trigger an alarm.
l Zone Sensitivity: Defines the relative amount of motion within the selected zone that will trigger an
event or alarm. Zone sensitivity can be set at a lower or higher setting than the overall sensitivity
setting for the rest of the scene or the Profile sensitivity setting for the selected behavior.
l Delay before alarm: Defines the amount of time an object must remain in a zone before triggering an
alarm.
Using Select Behaviors—Ideal Situations
The following sections describes the function of each Select Behavior and the ideal situation in which to
use it.
Using Abandoned Object
The Abandoned Object behavior detects objects placed within a defined zone and triggers an alarm if
objects remain in the zone longer than the user-defined time allows.