Operation Manual
Table Of Contents
- Important Notices
- Accessing the Camera
- Accessing the Live Video Page
- System Menu
- Using the Network & Security Menu
- Using the Imaging Menu
- Configuring Exposure Settings
- Configuring Focus Settings
- Setting White Balance
- Using Window Blanking
- Configuring Options in the PTZ Menu
- Using A/V Streams Menu
- Events
- Configuring Sources
- Configuring Handlers
- Configuring an Event Handler: Send Email
- Configuring an Event Handler: Upload JPEG to FTP Server
- Configuring an Event Handler: Write JPEG to SD Card
- Configuring an Event Handler: Run Pattern
- Configuring an Event Handler: Go to Preset
- Configuring an Event Handler: Run Tour
- Configuring an Event Handler: Run Scan
- Configuring an Event Handler: Open/Close Relay
- Configuring an Event Handler: Display Overlay
- Configuring an Event Handler: Play Audio
- Configuring an Event Handler: Write Recording to SD Card
- Configuring an Event Handler: Upload Recording to FTP Server
- Deleting an Event Handler
- Analytic Configuration
- Event Stream
- Contacting Pelco for Troubleshooting
Spectra Enhanced 7 Operations Manual, PTZDome Cameras
C6653M-B | 06/20
41
You can configure multiple analytic behaviors. Each analytic behavior has its own settings, and many
analytic behaviors also require you to configure zones that the camera will monitor for activity. The analytic
behaviors available to your camera are dependent on your model and firmware version.
Configuring Basic Analytics
The Basic menu contains Motion Detection, Edit Mask, and Sabotage Detection functions.
Configuring Motion Detection
Note: Motion Detection requires a mask to be drawn to indicate where the camera should look for
motion. Use the Edit Mask controls to setup the mask.
1. Check Enabled.
2. Enter an Event logging (profile) name.
3. Establish an alarm priority by selecting Alarm Severity of Minor, Normal, Major, or Critical.
4. Choose a Sensitivity level of Low, Medium, or High to establish what amount of change in motion
within the camera's field view that triggers a handler behavior.
5. User the slider bar or text input box to set the Threshold % in how much motion needs to occur in
order to trigger the alarm.
Configuring Edit Mask Mode
1. Select the Edit Mask mode option to Draw or Erase zones
2. Select a Rectangle or Paintbrush (line) drawing Tool.
3. Use the mouse cursor to Draw the mask or Erase sections of the mask.
l Revert back to a previous state by clicking Undo.
l Clicking Redo will reverse the Undo action.
4. Click Save.
Configuring Sabotage Detection
1. Check Enabled.
2. Establish the sensitivity to motion that will trigger a handler behavior by choosing from Low,
Medium, or High.
3. Enter an Event logging (profile) name.
4. Establish an alarm priority by selecting Alarm Severity of Minor, Normal, Major, or Critical.
5. Click Save.
Configuring Enhanced Analytics
The Enhanced analytic configuration menu contains Scene Settings, Select Behaviors, Drawing Tools, a
Zone list, and Zone settings.
Configuring the Scene Settings
Depending on the chosen Select Behavior, one or more of the following Scene Settings will be available.
Scene Settings is only available if you have configured a preset. Clicking the Manage Presets link will
direct you to the Presets PTZ tab where you can create or edit camera presets.
To configure the scene settings: