Operation Manual

Spectra Enhanced 7 Operations Manual, PTZDome Cameras
C6653M-B | 06/20
38
6. (Optional) If available, select the source(s)that you want to trigger this event handler.Sources are
configured from the Events tab Sources page.
7. Click Save.
Configuring an Event Handler: Run Tour
You must define a Preset Tour before you can create a Run Tour event handler. Preset tours are configured
from the Imaging tab Preset Tours page.
1. Click New Handler or select the handler you want to reconfigure.
2. Provide a name, between 2 and 23 alphanumeric characters, for the event handler in the Name box.
3. Select the Run Tour handler type.
4. Select a tour from the Tour drop-down menu.
5. (Optional) Set time filters to determine the days and times during which the handler will be active. If
you do not select any filters, the handler will remain active at all times. All time values must be
formatted in 24-hour notation.
6. (Optional) If available, select the source(s) that you want to trigger this event handler.Sources are
configured from the Events tab Sources page.
7. Click Save.
Configuring an Event Handler: Run Scan
This event handler runs a preset scan when an event source is triggered. You must define a Scan before
you can create a Run Scan event handler. Scans are configured from the Imaging tab Scans page.
1. Click New Handler or select the handler you want to reconfigure.
2. Provide a name, between 2 and 23 alphanumeric characters, for the event handler in the Name box.
3. Select the Run Scan handler type.
4. Select the scan from the pull-down menu.
5. (Optional) Set time filters to determine the days and times during which the handler will be active. If
you do not select any filters, the handler will remain active at all times. All time values must be
formatted in 24-hour notation.
6. (Optional) Select one or more sources that you want to trigger this event handler.Sources are
configured from the Events tab Sources page.
7. Click Save.
Configuring an Event Handler: Open/Close Relay
The Open/Close handler opens or closes a relay when a source event occurs.
1. Click New Handler or select the handler you want to reconfigure.
2. Provide a name, between 2 and 23 alphanumeric characters, for the event handler in the Name box.
3. Select the Open/Close Relay handler type.
4. Select the individual relay you want to trigger when an event occurs from the Relay drop-down
menu.
5. Select the Relay Mode: Pulse or Trigger.
6. Use the On Time controls to set the amount of time the relay will remain open, up to 200 seconds.
7. Use the Off Time controls to set the amount of time the relay will remain closed, up to 200 seconds.