Operation Manual
Table Of Contents
- Important Notices
- Accessing the Camera
- Accessing the Live Video Page
- System Menu
- Using the Network & Security Menu
- Using the Imaging Menu
- Configuring Exposure Settings
- Configuring Focus Settings
- Setting White Balance
- Using Window Blanking
- Configuring Options in the PTZ Menu
- Using A/V Streams Menu
- Events
- Configuring Sources
- Configuring Handlers
- Configuring an Event Handler: Send Email
- Configuring an Event Handler: Upload JPEG to FTP Server
- Configuring an Event Handler: Write JPEG to SD Card
- Configuring an Event Handler: Run Pattern
- Configuring an Event Handler: Go to Preset
- Configuring an Event Handler: Run Tour
- Configuring an Event Handler: Run Scan
- Configuring an Event Handler: Open/Close Relay
- Configuring an Event Handler: Display Overlay
- Configuring an Event Handler: Play Audio
- Configuring an Event Handler: Write Recording to SD Card
- Configuring an Event Handler: Upload Recording to FTP Server
- Deleting an Event Handler
- Analytic Configuration
- Event Stream
- Contacting Pelco for Troubleshooting
Spectra Enhanced 7 Operations Manual, PTZDome Cameras
C6653M-B | 06/20
35
Configuring a Timer Event Source
A timer event source triggers an event at specified intervals of time.
1. Click New Source, or select the source you want to edit.
2. Provide a name, between 2 and 23 alphanumeric characters, for the event source in the Name box.
3. Select Timer from the Type drop-down menu.
4. Configure the frequency of the event, including the units of time available, in the pull-down menu.
5. (Optional) If available, select the handler(s) that you want to associate with this source. Handlers
are configured from the Events tab Handler page.
6. Click Save.
Configuring a System Event Source
A system source triggers an event when your camera boots.
1. Click New Source, or select the source you want to edit.
2. Provide a name, between 2 and 23 alphanumeric characters, for the event source in the Name box.
3. Select System from the Type menu.
4. (Optional) If available, select the handler(s) that you want to associate with this source. Handlers
are configured from the Events tab Handler page.
5. Click Save.
Configuring a Park Action Event Source
A park action event source triggers an event if the camera is inactive for a specified period of time.
1. Click New Source, or select the source you want to edit.
2. Provide a name, between 2 and 23 alphanumeric characters, for the event source in the Name box.
3. Select Park Action from the Type menu.
4. Configure the dwell time (the amount of inactivity before the event handler starts). Dwell time must
be greater than 30 seconds.
5. (Optional) If available, select the handler(s) that you want to associate with this source. Handlers
are configured from the Events tab Handler page.
6. Click Save.
Configuring a Network Loss Event Source
Network Loss Event Source triggers an event if the connection to a network is lost.
1. Click New Source, or select the source you want to edit.
2. Provide a name, between 2 and 23 alphanumeric characters, for the event source in the Name box.
3. Select NetworkLoss from the Type menu.
4. Enter the IPv4 IP address that will be monitored for ping requests.
5. Establish the frequency, in minutes, which the network device is contacted.
6. Click Save.
Deleting an Event Source
1. Select the source that you want to delete.
2. Click Delete Source to remove the event source.