Operation Manual
Table Of Contents
- Important Notices
- Accessing the Camera
- Accessing the Live Video Page
- System Menu
- Using the Network & Security Menu
- Using the Imaging Menu
- Configuring Exposure Settings
- Configuring Focus Settings
- Setting White Balance
- Using Window Blanking
- Configuring Options in the PTZ Menu
- Using A/V Streams Menu
- Events
- Configuring Sources
- Configuring Handlers
- Configuring an Event Handler: Send Email
- Configuring an Event Handler: Upload JPEG to FTP Server
- Configuring an Event Handler: Write JPEG to SD Card
- Configuring an Event Handler: Run Pattern
- Configuring an Event Handler: Go to Preset
- Configuring an Event Handler: Run Tour
- Configuring an Event Handler: Run Scan
- Configuring an Event Handler: Open/Close Relay
- Configuring an Event Handler: Display Overlay
- Configuring an Event Handler: Play Audio
- Configuring an Event Handler: Write Recording to SD Card
- Configuring an Event Handler: Upload Recording to FTP Server
- Deleting an Event Handler
- Analytic Configuration
- Event Stream
- Contacting Pelco for Troubleshooting
Spectra Enhanced 7 Operations Manual, PTZDome Cameras
C6653M-B | 06/20
14
Note: Exports are limited to 15-minute clips.
Viewing Diagnostics
Go to System > Diagnostics to get information on Power, Client Connections and Temperature.
Viewing Client Connections
Client Connections displays the number of active streams by Client Address, Stream type, and Duration.
Viewing Temperature Information
The Temperature setting displays the current processor temperature along with a graphical display of the
Maximum, Minimum, and Average Processor Temperature (C°) for the current session and historical
sessions.
Viewing Power Information
The current Input Voltage and Power Usage statistics are displayed within the Power section of the
Diagnostics display. Maximum, Minimum, and Average Input Voltage (mV) and Power Usage (mW)
statistics are graphically displayed for the current session and historical sessions.