Operation Manual
Table Of Contents
- Important Notices
- Accessing the Camera
- Accessing the Live Video Page
- System Menu
- Using the Network & Security Menu
- Using the Imaging Menu
- Configuring Exposure Settings
- Configuring Focus Settings
- Setting White Balance
- Using Window Blanking
- Configuring Options in the PTZ Menu
- Using A/V Streams Menu
- Events
- Configuring Sources
- Configuring Handlers
- Configuring an Event Handler: Send Email
- Configuring an Event Handler: Upload JPEG to FTP Server
- Configuring an Event Handler: Write JPEG to SD Card
- Configuring an Event Handler: Run Pattern
- Configuring an Event Handler: Go to Preset
- Configuring an Event Handler: Run Tour
- Configuring an Event Handler: Run Scan
- Configuring an Event Handler: Open/Close Relay
- Configuring an Event Handler: Display Overlay
- Configuring an Event Handler: Play Audio
- Configuring an Event Handler: Write Recording to SD Card
- Configuring an Event Handler: Upload Recording to FTP Server
- Deleting an Event Handler
- Analytic Configuration
- Event Stream
- Contacting Pelco for Troubleshooting
Spectra Enhanced 7 Operations Manual, PTZDome Cameras
C6653M-B | 06/20
11
Restoring All Camera Defaults
If necessary, you can reset your camera settings to the factory defaults.
1. Click Restore All Camera Defaults and choose one of two options:
l Soft Restore will reset the camera back to factory defaults with the exception of network
settings. All user settings and customizations will be lost and cannot be recovered.
l Hard Restore will reset the camera back to factory defaults. All user settings and
customizations and network settings will be lost and cannot be recovered.
Backing Up and Restoring Settings
Go to the System page and click the Backup and Restore tab.
If you accidentally change a setting or need to recover from a factory reset, you can back up and restore
your device configuration. Camera backup files are stored in bin format.
Note: The restore feature is not intended to automatically configure multiple devices or to recover
settings following a firmware upgrade.
Backing Up Camera Settings
1. Click Generate Backup File
2. Click Download Now, and then specify the directory in which to save your backup file.
3. Click OK to save the backup file.
Restoring Camera Settings from a Backup
1. Click Browse,and then click to select the backup file.
2. Click OK.
3. Click Choose File, and then locate the device's backup file.
4. Click Upload and Restore; to restart the camera and restore the camera settings.
Locating System Information
The information settings page includes read-only fields for the Firmware Version, Hardware Version, Model
Number, and Serial Number of the camera. This information is typically required by Pelco Product Support
for troubleshooting purposes.
Updating Firmware
Go to System > Firmware to access System Information and perform Firmware Updates.
System Information includes read-only fields for the firmware version, hardware version, model number,
and serial number of the camera. This information is typically required by Pelco Product Support for
troubleshooting purposes.
The camera firmware can be upgraded or downgraded.
1. Click Browse to select the firmware you would like to upgrade/downgrade (ppm file).
2. Click Upload.
Note: Upgrading to version 3.3.x.x firmware requires user(s) to exist on the camera. Otherwise,
the firmware update will fail.