I N S T A L L A T I O N PMCL-R Series Monitor Mount C2220M-A (1/06)
Important Safety Instructions 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Only use attachments/accesories specified by the manufacturer. 6. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the aparatus. When a cart is being used, use caution when moving cart/apparatus combination to avoid injury from tip-over. 7.
Installation The following parts are supplied: Qty Description 2 Preassembled rack mounts 8 Screws, 10-32 x 0.750-inch, Phillips, pan head, black 8 Nylon washers 4 Screws, M4 x 0.70 x 6 mm, Phillips, pan head, stainless steel 4 Lock washers 1. Tighten the lock nuts (refer to Figure 1) so they are loose enough to allow the brackets to move but tight enough to hold them in place. 2. Attach the rack mounts to the monitor using the four stainless steel, pan head screws and lock washers.
PRODUCT WARRANTY AND RETURN INFORMATION WARRANTY Pelco will repair or replace, without charge, any merchandise proved defective in material or workmanship for a period of one year after the date of shipment. Exceptions to this warranty are as noted below: • Five years on FT/FR8000 Series fiber optic products. • Three years on Genex ® Series products (multiplexers, server, and keyboard).
