Installation/Operation PMCS15A, PMCS17A, and PMCS19A Super-High Resolution Color Monitors C1991M-C (9/04) Pelco • 3500 Pelco Way • Clovis, CA 93612-5699 USA • www.pelco.
IMPORTANT SAFETY INSTRUCTIONS 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. 8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9.
REGULATORY NOTICES This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. RADIO AND TELEVISION INTERFERENCE This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules.
INSTALLATION The monitor may be placed on any flat surface (desk or table) or rack-mounted. To rack-mount the monitor follow the instructions supplied with the rack mount kit. Video and Power Connections 1. Video Cable Connection (Refer to Table A for video coaxial cable requirements.) a. Connect the video cable to the BNC video input labeled V1 IN on the back panel of the monitor. If the installation requires a second video input, connect a video cable to the BNC video input labeled V2 IN. b.
Table A. Video Coaxial Cable Requirements Cable Type* Maximum Distance RG59/U RG6/U RG11/U 750 ft (229 m) 1,000 ft (305 m) 1,500 ft (457 m) * Minimum cable requirements: 75 ohms impedance All-copper center conductor All-copper braided shield with 95% braid coverage V1-H V1-L V2-H CAMERA V1 IN V2 IN AU1 IN AU2 IN V1 OUT V2 OUT AU1 OU T AU2 OUT S-HI S-VHS IN CAMERA V2-L VCR S-LO S-VHS OU T VCR Figure 2.
OPERATION 1. Set the video format switch located on the front panel to one of the following settings: VIDEO1 - Composite video (NTSC/PAL) mode VIDEO2 - Composite video (NTSC/PAL) mode for two, video input operation S-VIDEO - S-VHS mode if the S-VHS input jack on the back of the monitor is used 2. If required adjust the picture using the control knobs on the front panel. Front Panel Adjustments TINT Color phase adjustment. Turn clockwise to increase the greenish tones in the picture.
SPECIFICATIONS ELECTRICAL Input Voltage Power Consumption PMCS15A PMCS17A PMCS19A Horizontal Resolution PMCS15A PMCS17A PMCS19A Visual Picture Size PMCS15A PMCS17A PMCS19A Sweep Linearity Speaker Output GENERAL Input/Output Video Audio S-Video Construction Finish Dimensions PMCS15A PMCS17A PMCS19A Weight PMCS15A PMCS17A PMCS19A 90-260 VAC, 50/60 Hz, autoranging 70 watts 95 watts Approximate 100 watts 700 TV lines 700 TV lines 800 TV lines 14-inch diagonal 16-inch diagonal 18-inch diagonal 10% 1.
PRODUCT WARRANTY AND RETURN INFORMATION WARRANTY Pelco will repair or replace, without charge, any merchandise proved defective in material or workmanship for a period of one year after the date of shipment. Exceptions to this warranty are as noted below: • Five years on FT/FR8000 Series fiber optic products. • Three years on Genex® Series products (multiplexers, server, and keyboard).
