Installation Manual

Web Viewer

SYSTEM SETTING

General Settings

Modify the system default settings of the encoder.

General Settings

Device Name : Set the name to use for the encoder.



The device name must be at least two (2) characters

and no more than 63 characters.

Time Settings

Time Server : Set the time to apply to the encoder.

None : Specify no time setting for the encoder.

DHCP : Specify the time from the DHCP server.

Manual : Select whether the encoder is to be set to

the domain of the IP address or NTP server.

Time Zone : Set the time zone relative to standard time

(GMT).

Current Date : Display the date and time set.

Channel Names

One input field for each channel on the encoder to allow specification of channel / camera name.

Generate System Log

It will create a system log file that can be used by Pelco Product Support for troubleshooting.

The System Log file will be automatically downloaded using the web browser.

The user will not be prompted for a file name. The downloaded file will be a tar compressed file with a file extension of .tgz.

The file name will be comprised of the characters “_log” appended to the encoder serial number.

Reboot Encoder

Restart the encoder.

Restore All Encoder Defaults

All settings will be restored to the factory default settings.