Installation Manual

English
|
25
Installation
Network Connection
PC Connection in the Local Network
You can connect the encoder to a PC in the same network and control or manipulate it on the PC monitor.
1.
Connect the network port in the rear panel to the router or hub.
2.
Connect the local PC to the router or hub.
3.
Enter the address in the address bar (web browser) of the local PC or of the dedicated software program in the
format of “http://IP address:web service port”.
(Ex : http://192.168.0.23:80) From the Network Setup screen, you can change the port number.

If you do not know the camera's IP address, you can locate it using the Pelco Device Utility Software.
4.
Provide the ID and password before logging in. Then, you can view the monitoring screen.
Access ID (factory default) : admin, P/W : admin.
J
For security purposes, change the password right after you purchase the product.
1 2
1 2
3 4
3 4
2 4
1 3
A1 A2 NO COM Tx+ Rx+
A3 A4 NC Tx- Rx-
Camera 1
Local PC Local PC
Broadband
router
Camera 2 Camera 3
Camera 4
1 2
1 2
3 4
3 4
2 4
1 3
A1 A2 NO COM Tx+ Rx+
A3 A4 NC Tx- Rx-
1 2
1 2
3 4
3 4
2 4
1 3
A1 A2 NO COM Tx+ Rx+
A3 A4 NC Tx- Rx-
4WANRESETPWR 3 2 1
Local PC Local PC
Broadband
router