Installation Manual

Installation
20
|
Installation
Connecting the terminal block
The terminal block has tension clamps instead of screw terminals. Use a small screwdriver to open the clamp for a particular lead.
Power Supply
Connect the DC 12V power adapter to the encoder’s power input terminal.
J
For safety reasons, make the connection when the power is not applied yet.
J
Arrange the cables and be careful not to peel off the cable coating.
J
Do not put the power cable under a carpet or rug. The power cord is usually grounded. However, even if it's not grounded,
never modify it on your own for grounding.
J
Do not insert multiple devices in a single power socket. This may cause a power overload.
1 2
1 2
3 4
3 4
2 4
1 3
A1 A2 NO COM Tx+ Rx+
A3 A4 NC Tx- Rx-
1
1
A1 A2 NO COM Tx+ Rx+
A3 A4 NC Tx- Rx-
1 2
1 2
3 4
3 4
2 4
1 3
A1 A2 NO COM Tx+ Rx+
A3 A4 NC Tx- Rx-
1 2
1 2
3 4
3 4
2
1
A1 A2 NO COM Tx+ Rx+
A3 A4 NC Tx- Rx-
Power adapter