Installation Manual

Installation
18
|
Installation
DESKTOP INSTALLATION
When installing the device on a horizontal surface such as a desktop, proceed as follows.
1.
Attach the rubber feet to the bottom of the unit to prevent surface damage.
2.
Place the device in a location that provides adequate space for wiring and cords at the front and back of the panel.
J
Do not place the device upright since that can lead to its falling over and becoming damaged. Placing the device upright will also block the flow of
air, which may cause it to overheat.
FACTORY DEFAULT
1.
Use a sharp-edged object (e.g. paper clip) to press and hold the Reset switch.
2.
Press and hold the switch for 10 seconds. Then, release it.
3.
When the encoder reset is completed, the system will restart by the factory default.
1
2
1
2
3
4
3
4
2
4
1
3
A1 A2 NO COM Tx+ Rx+
A3 A4 NC Tx- Rx-
1
2
1
2
3
4
3
4
2
4
1
3
A1 A2 NO COM Tx+ Rx+
A3 A4 NC Tx- Rx-
1 2
1 2
3 4
3 4
2 4
1 3
A1 A2 NO COM Tx+ Rx+
A3 A4 NC Tx- Rx-
1
1
A3 A4 NC Tx- Rx-