Installation Manual

English
|
17
Installation
To install the NET5500 Series encoder in a rack
1.
Remove the three Phillips flat head screws from each side of the unit. Set the screws aside.
2.
Align the three screw holes in the mounting brackets with the threaded holes on the left and the right sides of the chassis.
3.
Using the six Phillips flat head screws, attach the mounting brackets to each side of the chassis.
4.
Insert and tighten the Phillips flat head screws you removed earlier.
5.
Align the two mounting bracket holes on each side with the screw holes on the rack.
6.
Insert and tighten the Phillips flat head screws (not supplied) to secure the unit in the rack.