Installation Manual

Installation

SYSTEM ORGANIZATION

MOUNTING IN A RACK

The NET5500 Series encoder mounts into an industry-standard 48 cm (19-inch) equipment rack. The NET5500 Series encoder

occupies 1 RU (4.45 cm or 1.75 inches) of vertical rack space. The hardware necessary to mount the NET5500 Series rack encoder

into a rack is supplied with the unit.

The rack must meet the following requirements

Rack standard : 48 cm (19 inches), EIA-310-D compliant (rear column required)

Rack column depth : 50.8 to 76.2 cm (20 to 30 inches)

Column mounting hole provisions : 10-32 UNF-2B threaded holes or square window holes on front and rear columns.

Door systems (optional) : Front doors must have at least 5.1 cm (2 inches) between the NET5500 Series encoder front bezel and the

inside of the door.

Rear doors may be used only on rack columns that more than 66 cm (26 inches) deep.

Make sure the NET5500 Series encoder is level.

Slots and openings in the cabinet provide ventilation to prevent the unit from overheating. Do not block these openings.

Installation

1 2

3 4

2 4

1 3

A1 A2 NO COM Tx+ Rx+

A3 A4 NC Tx- Rx-

PTZ

Camera

Monitor

NETWORK

Adapter MIC

Cameras