Manual

12
|
Installation
Installation
SYSTEM ORGANIZATION
WALL MOUNTING
1.
Use drill bit of 5 mm (0.20 in.) diameter and drill on the marked positions, drill to have 3 cm (1.18 in.) deep holes. Clean the holes
after drilling.
2.
Insert an anchor for each hole. Fully insert anchors by lightly hammering the anchor head with a hammer/rubber hammer.
3.
Place the encoder on the desired wall and fasten screws through the 4 holes using a screwdriver.
J
Use the provided screws when installing the bracket on the product. If you use any other screws, it may cause damage to the product.
PTZ
Camera
Adapter
Monitor
NETWORK
MIC
Camera