Spec Sheet

TECHNICAL SPECIFICATIONS
MODELS
IXES1 Sarix 0.5 MPx with SureVision, low-light,
WDR, day-night, network camera with
built-in Pelco analytics
IXE11 Sarix 1 MPx (720p) with SureVision, low-light,
WDR, day-night, network camera with
built-in Pelco analytics
IXE21 Sarix 2 MPx (1080p) with SureVision,
low-light, WDR, day-night, network camera
with built-in Pelco analytics
IXE31 Sarix 3 MPx (1080p) with SureVision,
low-light, WDR, day-night, network camera
with built-in Pelco analytics
CAMERA
Imaging Device 1/3-inch
Imager Type CMOS
Imager Readout Progressive scan
Highest Resolution
3 MPx 2048 x 1536
2 MPx 1920 x 1080
1 MPx 1280 x 960
0.5 MPx 800 x 608
Signal-to-Noise Ratio >60 dB
Auto Back Focus Yes
Electronic Shutter Range
0.5 ~ 1/48,000 sec
True Wide Dynamic Range Up to 100 dB*
White Balance Range 2,000° to 10,000°K
Sensitivity f/1.2; 2,850°K; SNR >20 dB
Color (33 ms) 0.1 lux
Color (500 ms) 0.005 lux
Mono (33 ms) 0.05 lux
Mono (500 ms) 0.0013 lux
Day/Night Capabilities Yes
Mechanical IR Cut Filter Yes, (ON/OFF/AUTO selectable), with
different set points on lux
*Sensor level is not inclusive of SureVision image processing.
AUDIO
Streaming Bidirectional: full or half duplex
Input/Output Line level/external microphone input;
600-ohm differential, 1 Vp-p max. signal level;
built-in microphone
Compression G.711 PCM 8 bit, 8 kHz mono at 64 kbit/s
NETWORK
Supported Protocols TCP/IP, UDP/IP (Unicast, Multicast IGMP),
UPnP, DNS, DHCP, RTP, RTSP, NTP, IPv4, IPv6,
SNMP v2c/v3, QoS, HTTP, HTTPS, LDAP
(client), SSH, SSL, SMTP, FTP, ARP, ICMP, and
802.1x (EAP)
Users
Unicast Up to 20 simultaneous users depending on
the resolution settings
Multicast Unlimited users H.264
Security Access Password protected
Software Interface Web browser view and setup
VIDEO
Video Streams Multiple simultaneous streams with up to
2 different configurations plus service
stream; the secondary stream is variable
based on the setup of the primary stream
Available Resolutions Two configurable streams as follows:
Note: Default Mbps values are based on High profile (30 ips; default IP GOP
length).
Frame Rate Up to 30, 25, 15, 12.5, 10, 5, 1 (depending on
the coding, resolution, and stream
configuration)
Video Encoding H.264 High, Main, or Base profiles; and
MJPEG
Bit Rate Control Constrained variable bit rate (CVBR), constant
bit rate (CBR), and variable bit rate (VBR) with
target range
Service Stream JPEG stream; the aspect ratio will be
consistent with the independent streams
MECHANICAL
Lens Mount CS mount; adjustable
Auto Iris Type DC drive
Camera Mount 1/4 in. UNC-20 screw;
top and bottom of camera housing
ELECTRICAL
Network Port RJ-45 connector for 100Base-TX
Auto MDI/MDI-X
Accessory Port Micro B USB connector for Pelco accessories
Cable Type Cat5 or better for 100Base-TX
Input Power PoE (
IEEE 802.3af, Class 3)
Power Consumption
9 W nominal
Current Consumption 350 mA maximum
Local Storage Micro SD, SDHC (see manual for details)
Alarm
Input 10 VDC maximum, 5 mA maximum
Output 0 to 15 VDC maximum, 75 mA maximum
Relay Output 32 VDC maximum; 150 mA maximum
Does not include optional accessories connected to accessory port.
Camera Model MPx
Max
Mbps
CVBR
Width Height
Aspect
Ratio
3 MPx 3.0 9.2 2048 1536 4:3
2 MPx 1.9 5.7 1600 1200 4:3
1 MPx 1.2 3.8 1280 960 4:3
0.5
MPx
0.5 2 800 608 4:3
0.3 1.5 640 480 4:3
0.08 0.5 320 240 4:3
3 MPx and 2 MPx 1080p 6 1920 1080 16:9
1 MPx 720p 2.9 1280 720 16:9
0.5
MPx
0.5 1.7 800 448 16:9
0.2 1.2 640 352 16:9
0.06 0.4 320 176 16:9