Manual

C3473M-C (10/10) 9
22. Turn the power off when cleaning the product. Do not use strong abrasive detergent when cleaning this
product as this may cause discoloration. When using a chemical cloth for cleaning, read the caution provided
with the chemical cloth product.
23. When dirt is hard to remove, use a mild detergent and wipe gently. Then, wipe off the remaining detergent
with a dry cloth.
24. If OVER HEAT appears on the display, the inside of the camera has become extremely hot. Immediately turn
off the power of the camera and contact your dealer.
25. (Applies to Super Dynamic 5 (SD5)™ models only.) This product has a dehumidifying device to keep the inside
at a low moisture level, preventing condensation. Dew may be produced depending on the conditions of
temperature, humidity, winds, and rain, and it may take time to dehumidify. Never seal the surfaces of the
dehumidifying device.
Figure 1. Dehumidifying Device
26. Installation work shall be performed in accordance with the technology standard of the electric installation.
27. The product is designed to be installed under eaves. Keep the product out of direct sunlight.
28. Contact your dealer for assistance if you are unsure of an appropriate site in your particular environment.
Make sure that the installation area is strong enough to hold the product, such as a concrete ceiling. Install
the camera in the foundation area of the architecture or where sufficient strength is assured. If a ceiling
board, such as plaster board, is too weak to support the total weight, the area shall be sufficiently reinforced.
29. Avoid installing this product in the following locations:
• Locations where a chemical agent is used such as a swimming pool (indoor and outdoor).
• Locations subject to steam and oil smoke such as a kitchen.
• Locations near flammable gas or vapor.
• Locations where radiation or x-ray emissions are produced.
• Locations where corrosive gas is produced, Locations where it may be damaged by briny air such as
seashores.
• Locations where the temperature is not within –10 °C to 50 °C (14 °F to 122 °F). When using the
heater unit, the product can be used at temperatures within –30 °C to 50 °C (–22 °F to 122 °F) and
humidity below 90%.
• Locations subject to vibrations. (This product is not designed for on-vehicle use.)
30. Avoid installing this system in moist or dusty places; otherwise, the lifetime of the internal parts may be
shortened.
31. Avoid installing the camera in a location with a high level of noise. Installation near an air conditioner, an air
cleaner, a vending machine, or the like causes noise.
32. Be sure to remove this product if it is not in use.
33. Keep the camera cable away from the lighting cable. Failure to observe this may cause noise.
ì
Dehumidifying Device