Manual

C3473M-C (10/10) 47
Wiring
WATERPROOF TREATMENT FOR THE CABLE JOINT SECTIONS
Adequate waterproof treatment is required for the cables when a camera with exposed cables is installed using
the mounting base, or when it is installed under the eaves of a structure. The camera body is waterproof, but the
cable ends are not waterproof.
Figure 41. Using Butyl Tape to Waterproof Power Cable
Figure 42. Using Butyl Tape to Waterproof Video Output Cable
NOTES:
• To install this product outdoors, be sure to waterproof the cables. The camera body is waterproof (IEC IP66 or
equivalent) only when the installation specified in this document and appropriate waterproofing are properly
performed. The bracket is not waterproof.
• The cable must be wound with butyl tape in a half-overlapping manner.
WARNING: Be sure to use the supplied butyl tape at the connection parts of the power cord and video
output cable to apply waterproof treatment. Stretch the tape to approximately twice its length and wind it
around the cable. Failure to observe this may cause water leakage resulting in malfunction.