Manual

46 C3473M-C (10/10)
(1) Align the cutout on the enclosure with the groove on the outside edge of the camera assembly.
Figure 40. Reattaching the Enclosure
(2) Tighten the three captive screws on the enclosure using the bit for tamperproof screws
(supplied). The recommended tightening torque is 0.78 N·m (0.58 lbf·ft).
c. When the indicator stops blinking and remains lit, back focus is adjusted automatically. After the back
focus is adjusted, the indicator turns off.
NOTES:
• Do not aim the camera at continuously moving objects.
• If, after changing to a steady light, the indicator blinks again, back focus adjustment may have failed. In this
case, check the back focus on the monitor.
ì
Cutout on the Enclosure
î
Groove on the Camera Assembly