Manual

42 C3473M-C (10/10)
NOTES:
• No operation for 10 seconds or more automatically clears the focus position indicator.
• You can change the angle of view by moving the zoom adjustment ring, and you can move the focus lock knob
to adjust the focus.
• The originally adjusted focus may be slightly off depending on the iris state resulting from the focal depth of
the lens. In such a case, open the aperture by darkening the subject as much as possible, and then adjust the
focus. This will prevent defocus.
• Use of ABF or BACK-FOCUS in the setup menu allows users to adjust the focus optimally in the range of the
capability to automatically follow the variation in illuminance.
• The out-of-focus level in a near-infrared light region may be higher than that in a visible light region.
Setting C/L-B/W of BACK-FOCUS SETUP to AUTO or PRESET in the setup menu allows users to adjust the focus
in both the near-infrared light and visible light regions (the variation in illuminance is not followed after focus
adjustment).
ADJUSTING THE CAMERA: COLOR AND DAY/NIGHT MODELS
1. Rotate the panning table (320-degree range) to adjust the panning position of the camera (refer to Figure 35).
The adjusting range is from +180 degrees (clockwise) to –140 degrees (counterclockwise).
2. Tighten the panning table lock screw.
Figure 35. Adjusting the Panning Position
WARNINGS:
• Do not touch the iris motor.
• Do not hold the camera by the lens unit when adjusting pan, tilt, or azimuth.
ì
Panning Table Lock Screw
î
Panning Table
LOCK
TOP
140°
180°