Manual

30 C3473M-C (10/10)
12. Use the bit for tamperproof screws (supplied) to tighten the captive fixing screws on both sides of the base
cover. The recommended tightening torque is 0.78 N·m (0.58 lbf·ft).
Figure 17. Tightening the Base Cover Fixing Screws
13. Remove the enclosure and inner dome (refer to Removing the Enclosure and Inner Dome on page 36).
14. Make adjustments to the camera (refer to Adjusting the Camera: Super Dynamic 5 (SD5)™ Models on
page 37).
15. Reattach the enclosure and inner dome (refer to Mounting the Enclosure and Inner Dome on page 45).
FLUSH MOUNTING
(Recommended for indoor installations only)
Figure 18. Installing Flush Mount Models
ì
Base Cover Fixing Screws
ì
Roof Space
î
Safety Wire Angle
ï
Safety Wire
ñ
Roof Space