Manual

22 C3473M-C (10/10)
USING A 2-GANG JUNCTION BOX
1. Mount the camera attachment (supplied) to the junction box installed on the wall or ceiling using the four
Phillips screws (supplied). The recommended tightening torque is 0.78 N·m (0.58 lbf·ft). Refer to Figure 6.
NOTES:
• For wall mounting, be sure that the TOP mark on the camera attachment faces upward.
• For ceiling mounting, the front side of the camera (indicated by the Pelco logo) shall be aligned in the
direction of the arrow and the FRONT mark on the camera attachment.
Figure 6. Mounting the Camera Attachment to a 2-Gang Junction Box
2. Mount the camera (refer to Figure 7 on page 23):
a. Connect the power cord and the video output cable (refer to Wiring on page 47).
b. Align the OPEN mark on the camera with the protrusion on the camera attachment.
ì
2-Gang Junction Box
î
Camera Attachment
F
R
O
N
T
TOP
FRONT
TOP