Manual

10 C3473M-C (10/10)
34. When the camera is used near a TV/radio antenna, strong electric field, or magnetic field (near a motor or a
transformer), images may be distorted and audible noise may be produced. In such a case, route the camera
cable through specialized steel conduit tubes.
35. Screws are not supplied with this product and must be locally procured. Prepare the screws according to the
material, structure, strength and other factors of the mounting area and the total weight of objects to be
mounted.
36. The mounting screws and bolts must be tightened with an appropriate tightening torque according to the
material and strength of the installation area. Do not use an impact driver. Failure to observe this may cause
overtightening and damage to the screws. When a screw is tightened, position the screw at a right angle to
the surface. After tightening the screws or bolts, perform a visual check to ensure adequate tightening and
there is no backlash.
37. Do not remove or loosen any of the seven screws on the rear of the camera; otherwise, water exposure may
cause damage or malfunction of the camera, or it may cause the camera to drop resulting in injury.
Figure 2. Screws on the Rear of the Camera