Installation Manual

6 C3914M (2/13)
7. Apply power to the camera. The camera will complete a configuration sequence. The LED below the
lens will blink for several minutes while the camera system boots. The LED will turn off when the
system boot cycle completes.
NOTE: If the camera is not connected to a DHCP server and DHCP is enabled, the configuration
sequence might take up to five minutes to complete.
8. If you do not know the camera’s IP address, install the Pelco Device Utility software available at
www.pelco.com. The utility will locate the assigned name, IP address, and MAC address of the
camera.
9. View the camera image using a Web browser.
10. Adjust the view angle (pan/tilt) of the camera. Rotate the camera body to adjust the pan. Rotate the
sensor ball to adjust the tilt.
Figure 7. Adjusting the Pan and Tilt
11. Attach the bubble to the ceiling mount using the magnet. (The magnet secures the bubble to the
ceiling mount.)
Figure 8. Attaching the Bubble
Adjust Pan
Adjust Tilt