Installation Manual

C3914M (2/13) 5
4. Tighten the two captive screws until the mount is held tightly to the ceiling.
Figure 4. Tightening the Screws
5. Connect the power wiring to the camera using one of the following options:
• Connect the network cable to the RJ-45 network port on the rear of the camera (refer to model
IL10-DP).
• If the camera is 24 VAC, also connect the 24 VAC power connector (supplied) to the rear of the
camera (refer to model IL10-DA). Then connect to a 24 VAC power supply (not supplied).
Figure 5. Connecting the Power Wiring
6. Insert the camera into the ceiling mount and lock it in place with the latch hooks. Verify that the
camera is securely attached to the ceiling mount by checking that the latch hooks have locked.
Figure 6. Inserting the Camera into the Ceiling Mount
Model IL10-DAModel IL10-DP