Installation Manual

4 C3914M (2/13)
Product Overview
Figure 1. Camera Connections (model IL10-DA shown)
Installation
1. Cut a 9.5 cm (3.75 inch) diameter hole in the ceiling.
2. Pull the wiring through the hole.
Figure 2. Pulling the Wiring
3. Install the ceiling mount, by pushing it into the ceiling, and then pull the wiring through the mount.
Figure 3. Installing the Ceiling Mount
ì
RJ-45 Network Port: Connects the camera to the IP network. Also supplies power, through the same
connector, to the PoE model of the camera.
î
1/4-inch x 20 Thread: Connects the camera to a mount.
ï
24 VAC Port: Supplies power to the 24 VAC model of the camera.
ñ
Reset Button: Reboots the camera or restores the camera’s factory default settings. This button is
recessed. Using a small tool, such as a paper clip, press and release the reset button once to reboot the
camera. Press and hold the reset button for 10 seconds to restore the camera to the factory default settings.