Installation Manual

C3914M (2/13) 3
Introduction
The Sarix
®
IL10 Series dome cameras are high-definition, IP network cameras that offer a cost-effective
solution for video security needs in small- and medium-sized businesses. The IL10 Series is part of Pelco’s
Value (V) range of cameras.
The IL10 Series dome camera is easy to install, offers ceiling mounting, and uses a standard Web browser
for easy remote setup and administration. The IL10 Series easily connects to Pelco IP and hybrid systems
such as Endura
®
version 2.0 (or later), Digital Sentry
®
version 7.3 (or later), and DX4700/DX4800 hybrid
video recorders. The camera is also conformant with ONVIF Profile S for connection with third-party video
management systems.
This document describes the installation and initial set-up procedures to begin operating the camera. For
more information about operating your camera, refer to the operation manual specific to the product.
NOTE: For additional information about product documentation in English and other languages, go to
www.pelco.com/sarix and navigate to the IL10 Series Web page.
MODELS
Getting Started
Before installing your device, thoroughly familiarize yourself with the information in the installation
section of this manual.
NOTES:
Pelco recommends connecting the device to a network that uses a Dynamic Host Configuration
Protocol (DHCP) server to address devices.
Do not use a network hub when configuring the network settings for the device.
To ensure secure access, place the device behind a firewall when it is connected to a network.
SUPPLIED PARTS LIST
IL10-DA Sarix IL10 Indoor Micro Dome Camera, 24 VAC
IL10-DP Sarix IL10 Indoor Micro Dome Camera, Power over Ethernet (PoE)
Qty Description
1 Camera
1 Ceiling mount
1 Bubble
1 24 VAC power connector (model IL10-DA only)
4 MAC address labels (extra)
1 Template for in-ceiling mount installation
1 IL10 Series Dome Camera Installation Quick Start Guide
1 Important Safety Instructions