Installation Manual

TECH SUPPORT: [phone] INTERNATIONAL: [phone] C5634M-A / REV 07-24-14
INSTALLATION AND OPERATION MANUAL FTV/FRV40D2(M,S)1(ST,FC)
FIGURE 7 – LED INDICATORS
FIGURE 6 – CONTACT SWITCH POSITIONS
LINK VIDEO (1 – 4) DATA (1 – 2) POWER
GREEN Communication link has been
established over optical fiber
Active video signal present
on the BNC connector.
Active data signal
present
Unit powered up
RED Communication link has not been
established
No video signal No data signal –
OFF Not powered up correctly – – Unit powered down
GND
+Vin
PWR
LINK
VIDEO 1
VIDEO 2
VIDEO3
VIDEO 4
POWER
123
4
OPTICAL
IN/OUT
VIDEOOUT
DATA 1
DATA 2
DATA 1
12 12
DATA 2
ON
CONTACT
1234
DATA 1
GND
BIAS
DOUT -
DOUT +
TERM
DIN -
DIN +
DATA 2
GND
BIAS
DOUT -
DOUT +
TERM
DIN -
DIN +
OUT
OUT
IN
IN
CONT
ACT
FRV40D2S1ST
4CHANNEL
DIGITAL VIDEORECEIVER
+
2CHANNELSOF
BI-DIRECT IONAL DATA
+
BI-DIRECTIO NAL CONTACT
GND
+Vin
PWR
LINK
VIDEO 1
VIDEO 2
VIDEO3
VIDEO 4
POWER
123
4
OPTICAL
IN/OUT
VIDEOOUT
DATA 1
DATA 2
DATA 1
12 12
DATA 2
ON
CO
NTAC
T
1234
DATA 1
GND
BIAS
DOUT -
DOUT +
TERM
DIN -
DIN +
DATA 2
GND
BIAS
DOUT -
DOUT +
TERM
DIN -
DIN +
OUT
OUT
IN
IN
CONTACT
FRV40D2S1ST
4CHANNEL
DIGITAL VIDEORECEIVER
+
2CHANNELSOF
BI-DIRECT IONAL DATA
+
BI-DIRECTIO NAL CONTACT
The four CONTACT switches on the front of the unit set the operating mode of the
CONTACT OUT terminal pair.
It can either function as an alarm to indicate fault conditions, or it can function as a
contact closure to indicate the state of the CONTACT IN terminal pair on the rear of the
unit at the other end of the fiber.
1 2 3 4
ON OFF OFF OFF Closed when optical Port has established link.
Open when Optical Port has lost link.
ON ON ON OFF Closed when Optical Port has established link and all video signals are present.
Open when Optical Port has lost Link, or if a Video signal is lost.
ON ON ON ON Contact Closure mode.
State based on CONTACT IN at other end of fiber link.