Installation Manual

18 C3952M-B (5/14)
INSTALLING THE DESICCANT CANISTER
FH-H SERIES ENCLOSURE MODELS
1. Remove the desiccant canister (supplied) from its packaging.
2. Remove the black panel covering the camera compartment.
3. Place the desiccant canister in the enclosure near the camera, making sure the small inspection window on the desiccant canister is facing
the camera.
4. Replace the black panel cover (refer to Figure 12). The grooved edge of the cover panel must face downward toward the camera
compartment for it to seat properly.
5. Close the lid and tighten the seven screws to seal the enclosure.
The desiccant canister reduces condensation within the enclosure. When the orange beads in the inspection window become clear, reactivate
the desiccant canister by placing it in a vented 150°C (300°F) oven for at least three hours, or until the beads are orange.
Figure 12. Removing and Replacing Black Panel Cover on FH-H Series Enclosure Models