Installation Manual
Table Of Contents
- Important Safety Instructions
- Troubleshooting Tips
- Regulatory Notices
- 1. Introduction
- 2. Installation
- 2.1(A) Inserting Screw Anchors
- 2.2(A) Connecting the Wiring
- 2.3(A) Mounting the Camera
- 2.4(A) Adjusting the Camera Position
- 2.5(A) Locking (fixing) the Camera Body
- 2.1(B) Disassembling the Camera
- 2.2(B) Connecting the Wiring
- 2.3(B) Mounting the Camera
- 2.4(B) Adjusting the Camera Position
- 2.5(B) Adjusting the Lens (if equipped with varifocal lens)
- 2.6(B) Completing the Installation
- 3. Specifications
- PRODUCT WARRANTY AND RETURN INFORMATION
Introduction
INTRODUCTIO
8
C3909M-EN (03/12)
1. FD1-F series: Cable Y used for surface run
power/video connector
FD1-IR series: Conduit hole used for
surface run power/video connector
2. Bottom case
3. Camera housing
4. Dome cover
5. Zoom lever
6. Focus lever
A. Video Output Terminal
B. DC12V Power Connector ( Red+/Black- )
Note: See Figure 2-3 for camera board controls.
1.4 Routine Maintenance
• The dome cover is an optical part. Use a soft, dry cloth to remove any fingerprints or dust.
• Clean the camera housing with a soft, dry cloth. For more stubborn stains, use a cloth dampened with
a small quantity of neutral detergent, then wipe dry.
Caution: Do not use volatile solvents such as alcohol, benzene or thinners to avoid damaging the
surface finish.
Figure 1-5 FD1-IRV9
Figure 1-4 FD1-IRF4