Installation Manual
Table Of Contents
- Important Safety Instructions
- Troubleshooting Tips
- Regulatory Notices
- 1. Introduction
- 2. Installation
- 2.1(A) Inserting Screw Anchors
- 2.2(A) Connecting the Wiring
- 2.3(A) Mounting the Camera
- 2.4(A) Adjusting the Camera Position
- 2.5(A) Locking (fixing) the Camera Body
- 2.1(B) Disassembling the Camera
- 2.2(B) Connecting the Wiring
- 2.3(B) Mounting the Camera
- 2.4(B) Adjusting the Camera Position
- 2.5(B) Adjusting the Lens (if equipped with varifocal lens)
- 2.6(B) Completing the Installation
- 3. Specifications
- PRODUCT WARRANTY AND RETURN INFORMATION
Installation
OSD Setup Menu
14
C3909M-EN (03/12)
2.4(B) Adjusting the Camera Position
The dome camera has three axes for positioning the camera. While monitoring the picture on the
monitor, adjust the camera position as follows:
• Pan Adjustment: Rotate 3D assembly in the base. Do not turn assembly more than 360° as this
may cause the internal cables to twist and disconnect or break.
• Tilt Adjustment: After loosening the screw on the bracket, position the camera as desired, then
tighten the screw back to the bracket.
• Horizontal Rotation: For wall mount and tilted ceilings, rotate the lens base (maximum 360°) until
you are satisfied with the field of view.
Figure 2-3(B) Camera Adjustment
FD1-IRF4
FD1-IRV9
1. Rotate 3D assembly in base for pan
adjustment
2. Tilt adjustment bracket and screw
for vertical adjustment
3. Axis ring for horizontal rotation for
wall mount and tilted ceilings
4. Focus lever
5. Zoom lever