Installation Manual
Table Of Contents
- Important Safety Instructions
- Troubleshooting Tips
- Regulatory Notices
- 1. Introduction
- 2. Installation
- 2.1(A) Inserting Screw Anchors
- 2.2(A) Connecting the Wiring
- 2.3(A) Mounting the Camera
- 2.4(A) Adjusting the Camera Position
- 2.5(A) Locking (fixing) the Camera Body
- 2.1(B) Disassembling the Camera
- 2.2(B) Connecting the Wiring
- 2.3(B) Mounting the Camera
- 2.4(B) Adjusting the Camera Position
- 2.5(B) Adjusting the Lens (if equipped with varifocal lens)
- 2.6(B) Completing the Installation
- 3. Specifications
- PRODUCT WARRANTY AND RETURN INFORMATION
Installation
OSD Setup Menu
13
C3909M-EN (03/12)
2.2(B) Connecting the Wiring
Refer to Figure 1-4 and Figure 1-5 to connect the video connect output connector (A) and DC 12V
power connector (B).
Caution: For DC power supply use, make sure the polarity is correct to avoid malfunction and / or
camera damage.
2.3(B) Mounting the Camera
1. Attach the mounting template to the wall or ceiling.
2. Drill two holes, then insert the screw anchors (#1) into the holes.
3. Secure the bottom case to the wall or ceiling with the TP4 x 15 mm tapping screws supplied (#2).
Note: Depending on the material of your mounting surface, you may require different screws and
anchors than those supplied.
Figure 2-2(B) Camera installation
1. Screw anchors (x2), supplied
2. TP4 x 15 tapping screws (x2),
supplied
FD1-IRF4 (typical)