Installation Manual
Table Of Contents
- Important Safety Instructions
- Troubleshooting Tips
- Regulatory Notices
- 1. Introduction
- 2. Installation
- 2.1(A) Inserting Screw Anchors
- 2.2(A) Connecting the Wiring
- 2.3(A) Mounting the Camera
- 2.4(A) Adjusting the Camera Position
- 2.5(A) Locking (fixing) the Camera Body
- 2.1(B) Disassembling the Camera
- 2.2(B) Connecting the Wiring
- 2.3(B) Mounting the Camera
- 2.4(B) Adjusting the Camera Position
- 2.5(B) Adjusting the Lens (if equipped with varifocal lens)
- 2.6(B) Completing the Installation
- 3. Specifications
- PRODUCT WARRANTY AND RETURN INFORMATION
Installation
OSD Setup Menu
10
C3909M-EN (03/12)
Figure 2-2(A) Camera Installation
2.4(A) Adjusting the Camera Position
The dome camera has two axes for positioning the camera. While monitoring the picture on the
monitor, adjust the camera position as follows:
• Pan Adjustment: Rotate 3D assembly in the base. Do not turn assembly more than 360° as this
may cause the internal cables to twist and disconnect or break.
• Tilt Adjustment: After loosening the screw on the bracket, position the camera as desired, then tighten
the screw back to the bracket.