Quick Start Guide

The Evolution Indoor camera is intended for mounting on flat surfaces,
such as walls or ceilings. Cabling can be configured to enter the
camera from the side or from within the mounting surface through the
rear of the mounting base. The latter option is recommended where
possible to offer improved vandal and tamper resistance.
Technical Support
For more detailed installation and operating information, please
refer to the: Evolution-12 Camera - User & Installation Manual
available at: pelco.com
For the latest update on User Manual, Data Sheet and camera
Firmware please visit: pelco.com
Tel: [phone] (International)
Email: [e-mail]
1 - Note the MAC address
Make a note of the camera’s install location and unique MAC
address, which can be found printed on the camera module
side label. This information may be needed during the camera
configuration.
Welcome
The Oncam Evolution-12 Indoor 360° Camera is designed to
be connected to an IP network, and it can be configured and
operated using a standard internet browser software.
This quick start guide describes the installation and
configuration procedures for a standard surface mount
camera application.
QUICK START GUIDE: Important
• Read these instructions carefully before installing or
operating this product.
• This product should be installed by a qualified service
person and the installation should conform to local and
national regulations.
• This product is not suitable for installation in a ceiling void
that is also used as an air handling space.
CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED
BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES
ACCORDING TO THE INSTRUCTIONS.
Evolution-12 Indoor Camera
QUICK START GUIDE
2 - Installation & Mounting options
2b. Remove the trim cover
Using the Torx driver (provided),
unscrew the side Torx screw then
carefully unclip the plastic trim cover
and set it aside.
2a. Preparing the surface
Attach the supplied drilling template
to the installation location. Drill holes
appropriately-sized and use wall
plugs and mounting screws.
For concealed-cable entry use the
supplied drilling template for pilot
hole drilling and drill the clearance
holes for cable access to the center
of the die-cast base.
2d. Re-assemble and apply power
Carefully seat the cover back on to
the base, making sure it clips in fully.
Rescrew the side screw with the
supplied Torx driver.
Remove the screen protection film
from the camera lens.
2c. Fix the camera module
Secure the camera base with
appropriate fixing screws. Ensure
the cables are pulled through the
base correctly.
The camera module can then be
fitted on to the base. The camera
module is secured to the base by
the thumb screw.
Power Input
UL/NRTL listed Class 2 , 12VDC, 1.0A or
LPS IEEE 802.3af standard PoE 48Vdc, 1A
Operating Temp. 0 to +40°C (-32 to +104°F)
Enclosure Aluminium die-cast base
Polycarbonate cover
Weight 0.58kg (1.08lbs)
WARNING: This is a Class A product. In a domestic
environment this product may cause radio interference in which
case the user may be required to take adequate measures.