Quick Start Guide

Evolution 05 Mini Indoor
QUICK START GUIDE
Welcome
The Oncam Evolution Mini Indoor 360° camera is designed
to be connected to an IP network. Configure and operate
the camera using a standard internet browser.
Described are the installation and configuration procedures
for a standard surface mount camera application.
Power Input
Power over Ethernet (PoE),
IEEE standard 802.3af
Operating
Temperature
0 to +40°C (-32 to +104°F)
Enclosure Polymer
Weight 0.22 kg (0.48 lbs)
Supplied Parts
• EVO-05 Mini Camera • Torx Screwdriver Bit
• Mounting Kit • Drilling Template
• Quick Start Guide
MAC Address
Document the camera’s installation location and unique
MAC address. Find the MAC address printed on the camera
label. This information may be needed during the camera
configuration.
Important
• Read these instructions carefully before
installing or operating this camera.
• This camera should be installed by a qualified
service person and the installation should
conform to local and national regulations.
• This product is only suitable for a surface mount
installation and should not be modified or
adapted for any type of plenum installation.
• Certified as FCC Class A. In a domestic
environment this camera may cause radio
interference in which case the user should take
adequate measures.
DANGER: RISK OF EXPLOSION IF
REPLACING A BATTERY WITH AN
INCORRECT BATTERY TYPE.
EVO-05LJD
EVO-05LID
Mounting & Installation
The Evolution Mini Indoor camera is intended for mounting
on flat surfaces, such as walls or ceilings. The camera
comes fitted with an RJ45 flying lead for connectivity to
data and PoE.
Two Torx screws attach the cover to the base.
1. Prepare the surface by using the supplied drilling
template. Drill holes appropriately sized for the two
base holes for use with mounting hardware.
NOTICE: Use the hardware appropriate for the
surface material that collectively supports at least
four times the weight of the camera.
2. Loosen the two cover screws using the Torx tool bit
and remove the trim cover.
3. Attach the camera module to a wall or ceiling surface
using the two base holes.
4. Route the network cable through the mounting plate
cable routing canal to allow concealed cable access
from the rear or side of the enclosure.
5. Reattach the trim cover to the camera base and apply
power.
6. Remove the screen protection.
Technical Support
For the A&E, Specification, Installation and User Manual,
Software and Firmware visit:
www.pelco.com
Tel: [phone] (International)
Email: [e-mail]