Installation Manual

C1354M-D (1/19) 8
8. Turn on the power. If the light turns on, turn off the power, and proceed with installation.
INSTALLING THE 100-240 VAC POWER MODULE
NOTES:
– The AC Mains unit shall be connected to a two pole circuit breaker rated maximum 15A or 20A.
– This product requires a surge protector device (SPD) or surge arrestor as part of the installation to address transient overvoltages
exceeding Overvoltage Category II, 2500 Vpk.
– High voltage wires must be covered by 0.4 mm thick UL recognized tubing.
– Ethernet and AUX cables must be covered by 0.4 mm thick UL recognized tubing.
1. Make sure your power is turned off while connecting the power module.
2. Remove the power module from the base of the device by loosening the three Phillips screws and lifting the module.
Figure 7. Removing the Power Module
3. Attach the base of the device to an Esprit mount (EWM or EPP2) using the three flathead screws supplied with the EPP2 and EWM mounts
(Refer to the Esprit Enhanced Mounts Installation manual for additional steps.).
Figure 8. Attaching the Base to a Mount
MOUNT
MOUNTING HOLES
BASE
MOUNTING
SCREWS