Installation Manual

C1354M-D (1/19) 10
b. Connect the Cat5e cable to the RJ-45 connector and/or connect SFP module(s). Attach the included ferrite to the network cable as
close as possible to the RJ-45 connector to reduce radio frequency electrical interference on the network cable. The cable should
have one turn/loop around the ferrite core.
c. Connect AUX (optional). Refer to Connecting to Aux (below).
6. Install mount; refer to the installation manual supplied with the mount for instructions.
7. Turn on the power. If the light turns on, turn off the power, and proceed with installation.
CONNECTING AUX (OPTIONAL)
Figure 11. Wiring Connections: 100 to 240 VAC
ì
Connects 100 to 240 VAC power to the system
î
Connects the system to IP network
ï
Connects 1 or 2 SFP modules (SFP Port 1 will auto-detect either 100 Mbps and 1 Gbps speeds. SFP Port 2 follows the speed
of Port 1 and requires a module in Port 1. Ensure the same speed transceivers are being used if both ports are utilized.)
Connects up to 2 relays, 4 alarms, audio, and reset using 20-26 AWG wire
Relay, Alarm, Audio, and Reset Connections
Designation Function
Relays
R2
Relay 2 N.C.
Relay 2 COM
Relay 2 N.O.
R1
Relay 1 N.C.
Relay 1 COM
Relay 1 N.O.
Reset
Alarms
A1 Alarm 1
A2 Alarm 2
A3 Alarm 3
A4 Alarm 4
Audio
Audio In
Audio Out
Port 1 Port 2
Note: All relays are specified for 32 VDC, 0 to 20mA (signal only).