Installation Manual
Table Of Contents
- Digital Sentry Hardware
- Contents
- Important Notices
- Package Contents
- Product Overview: Front
- Product Overview: Rear
- Placing on a Desktop
- Product Serial Number Label Placement
- Installing a DSSRV-RAID Controller Card
- Installing the SCSI Card
- Installing an ENC5400 Capture Card
- Mounting in a Rack
- Installing the Hard Drive Array
- Connecting an ENC5516
- Connecting an Uninterruptible Power Supply
- Connecting to the Network
- Connecting the Power Supply
- Connecting the Power Supply
- Shutting Down the Unit
- Enabling SNMP Services
- Enabling Serial Ports in the BIOS
- Digital Sentry Port Assignments
- Troubleshooting
- Technical Specifications
9
Product Overview: Rear
Figure 1: Rear Panel Layout
Placing on a Desktop
WARNING: Do not place the unit on its side; in this position, the unit is likely to fall over and may cause equipment damage or personal
injury.
1. Verify that the rubber feet are attached to the bottom of the unit. If not, secure the rubber feet to the bottom of the unit.
2. Position the unit to allow for cable and power cord clearance at the rear.
1 Rear Chassis Fan
2 Power Receptacle
3 VGA Port
4
Ethernet Ports
• Network Port 1 (left is primary)
• Network Port 2 (right is secondary)
5 Expansion Slots
6 Serial Ports
7 Reserved (do not use)
8 Audio Output
9 Audio Input
10 USB 3.0 Ports
11 USB 2.0 Ports
12 DisplayPort Connectors
13 Digital Visual Interface (DVI) Connector