Installation Manual
Table Of Contents
- Digital Sentry Hardware
- Contents
- Important Notices
- Package Contents
- Product Overview: Front
- Product Overview: Rear
- Placing on a Desktop
- Product Serial Number Label Placement
- Installing a DSSRV-RAID Controller Card
- Installing the SCSI Card
- Installing an ENC5400 Capture Card
- Mounting in a Rack
- Installing the Hard Drive Array
- Connecting an ENC5516
- Connecting an Uninterruptible Power Supply
- Connecting to the Network
- Connecting the Power Supply
- Connecting the Power Supply
- Shutting Down the Unit
- Enabling SNMP Services
- Enabling Serial Ports in the BIOS
- Digital Sentry Port Assignments
- Troubleshooting
- Technical Specifications
25
Connecting an Uninterruptible Power Supply
While UPS units supply backup battery power, the unit works in conjunction with the SmartUPS from APC. The SmartUPS signals the
unit to begin a graceful shutdown if the UPS standby power falls below a specific threshold.
1. Shut down the unit.
2. Connect a power cord from the unit power supply to a standard wall outlet.
3. Connect a power cord from the UPS to a standard wall socket or other power source.
4. Connect a USB cable from the APC SmartUPS to the USB connector on the unit.
5. Turn on the UPS.
6. Turn on the unit.
Figure 1: Connecting a UPS
UPS
POWER SOURCE
INPUT POWER
USB
OUTPUT POWER