Installation Manual

20
Mounting in a Rack
Do not block slots and openings in the cabinet. These provide ventilation to prevent the unit from overheating. Never place the unit near
or over a radiator or heat register. When placing the unit in a rack, be sure to provide proper ventilation.
1. Install the chassis handles:
a. Align the screw holes on the chassis handles and the chassis.
b. Insert and tighten the four 10-32 x 0.5-inch Phillips flat head screws with a Phillips screwdriver.
2. Remove the chassis brackets from the sliding brackets:
a. Slide each chassis bracket away from the sliding bracket until it locks in place.
b. Press the release lever up or down (depending on the rail) to release the chassis bracket from the sliding bracket. Press down
on the release lever for the right set of rails and press up for the left set of rails.
Figure 1: Remove the Chassis Brackets from the Sliding Brackets
3. Attach one chassis bracket to each side of the unit. Use four M4*6L-H2.5 round head nickel screws for each bracket. Attach the
chassis brackets so that the slotted ends are positioned toward the rear of the unit.
Figure 2: Attach the Mounting Brackets
4. If necessary, remove the rubber feet from the underside of the unit.
5. Attach a front and rear L-shaped bracket to the left and the right sliding brackets using two M4*6L-H2.5 round head nickel screws.
Leave all eight of the screws untightened.