Installation Manual
Table Of Contents
- Digital Sentry Hardware
- Contents
- Important Notices
- Package Contents
- Product Overview: Front
- Product Overview: Rear
- Placing on a Desktop
- Product Serial Number Label Placement
- Installing a DSSRV-RAID Controller Card
- Installing the SCSI Card
- Installing an ENC5400 Capture Card
- Mounting in a Rack
- Installing the Hard Drive Array
- Connecting an ENC5516
- Connecting an Uninterruptible Power Supply
- Connecting to the Network
- Connecting the Power Supply
- Connecting the Power Supply
- Shutting Down the Unit
- Enabling SNMP Services
- Enabling Serial Ports in the BIOS
- Digital Sentry Port Assignments
- Troubleshooting
- Technical Specifications
19
Installing a 4-Port Capture Card
1. Unscrew and remove the metal filler bracket for the PCI slot to the left of the PCIe slot where the 2-port card is installed.
2. Align the card with the PCI slot.
3. Gently press down on the card so that it is properly seated in the PCI slot.
4. Connect the 2- and 4-port cards using the 20p flat cable (supplied).
Figure 2: Installing a 4-Port Capture Card
5. Insert and tighten the metal bracket screw to secure the card.