Installation Manual
Table Of Contents
- Digital Sentry Hardware
- Contents
- Important Notices
- Package Contents
- Product Overview: Front
- Product Overview: Rear
- Placing on a Desktop
- Product Serial Number Label Placement
- Installing a DSSRV-RAID Controller Card
- Installing the SCSI Card
- Installing an ENC5400 Capture Card
- Mounting in a Rack
- Installing the Hard Drive Array
- Connecting an ENC5516
- Connecting an Uninterruptible Power Supply
- Connecting to the Network
- Connecting the Power Supply
- Connecting the Power Supply
- Shutting Down the Unit
- Enabling SNMP Services
- Enabling Serial Ports in the BIOS
- Digital Sentry Port Assignments
- Troubleshooting
- Technical Specifications
17
Preparing the Unit for the SCSI Card
1. Shut down the unit.
2. Disconnect the power.
3. Disconnect any cables restricting access.
4. If mounted in a rack, unscrew the fasteners and carefully lift the unit out of the rack (two people may be required).
5. Place the unit on a flat surface with ample workspace.
6. Unlock and open the bezel.
7. Use a Phillips screwdriver to remove the case cover screws.
8. Remove the case cover by lifting it up. Set aside the case cover.
Opening the Chassis
When opening the chassis, ensure that the unit is turned off, disconnected from power, and you are wearing a properly grounded ESD
wrist strap.
1. Unlock and open the bezel.
2. Use a Phillips screwdriver to remove the chassis cover screws. There are two screws on the top front, two screws on the left and
right sides, and three screws on the rear.
3. Carefully lift and remove the chassis cover.