Installation Manual
Table Of Contents
- Digital Sentry Hardware
- Contents
- Important Notices
- Package Contents
- Product Overview: Front
- Product Overview: Rear
- Placing on a Desktop
- Product Serial Number Label Placement
- Installing a DSSRV-RAID Controller Card
- Installing the SCSI Card
- Installing an ENC5400 Capture Card
- Mounting in a Rack
- Installing the Hard Drive Array
- Connecting an ENC5516
- Connecting an Uninterruptible Power Supply
- Connecting to the Network
- Connecting the Power Supply
- Connecting the Power Supply
- Shutting Down the Unit
- Enabling SNMP Services
- Enabling Serial Ports in the BIOS
- Digital Sentry Port Assignments
- Troubleshooting
- Technical Specifications
14
12. Run the multilane SATA cables through the slot on the inside left of the unit.
Figure 6: Running the Cables Through the Cable Slot
13. Connect the other end of the P5 cable to the motherboard for the optical drive on the DSSRV2-DVD.
14. Connect the multilane SATA cable plugs to the 4-lane connectors on the card.
NOTE: The bottom DS-SRV-RAID connector (SAS_1) must be used for the first set of drives (HD1 to HD4). The top DS-SRV-RAID
connector (SAS_0) must be used for the second set of hard drives (HD5 and HD6). Only one plug is required for the DSSRV2-DVD.
Figure 7: Connecting the Cables to the RAID Controller Card
15. Secure the power and multilane SATA cables by bundling them with cable ties.
16. Close the chassis and insert the drive carriers to complete the installation process.
Disabling UEFI Booting
1. Restart the system.
2. Press Delete repeatedly while the system is starting up to access the BIOS.
3. Modify the boot order to ensure that the unit boots from a non-UEFI device.